Oberheim Matrix-12 User Manual

3. While holding STORE, type in the 2-digit number of the "destination"
Patch - the new Patch where you want the source patch to go. The
Patch originally in this location will be replaced by the source Patch.
When you have finished editing the MULTI Patch, you must STORE the
edited
version if you intend to keep it.
VOICES 1-6/VOICES 7-12 Button
The PROGRAMMER display permits you to work with only six Voices at one
time. The VOICES 1 -6/VOICES 7-12 button permits switching between the
two banks of Voices in order to view their displays. You can switch between
the two Voice Banks at anytime in MULTI PATCH Mode.
This switching capability is active at all times when the MATRIX-12 is in
MULTI PATCH Mode. Because each Voice can be manipulated individually in
this Mode, you are permitted to select between Voice Banks as often as
needed.
EDIT COMPARE
When the MULTI Patch number is underlined, this indicates that this particular
MULTI Patch is currently selected. If you make any changes at all to a Patch,
the Edit Indicator dot will appear in the lower right-hand corner of the Patch
number to remind you that the Patch has been edited. You are able to
compare the edited version of the Patch with the original programmed
version:
• If you have edited a MULTI Patch, press the MULTI PATCH button once to
begin comparing. The underline will disappear and the Patch number will
flash off and on. The MATRIX-12 will recall the programmed version of the
Patch and play ing the synthesizer will allow you to hear what the Patch
sounded like before you started making changes.
• Selecting different Pages will also permit you to view the original settings
of the Patch as well. This feature is extremely useful, especially if you have
made many changes and need to see the original values.
• If you have edited one of the Patches assigned to a Voice within a MULTI
Patch, you may also compare this single edited Patch with its Stored
version. Press the PATCH EDIT button beneath the Patch number and, as
always, the underline will disappear and the number of the Patch assigned
to this Voice will flash. Pressing the PATCH EDIT button again stops the
compare process.
Comparing in MULTI PATCH Mode does have some limitations, however, just
as with comparing SINGLE Patches:
• You cannot perform any new edits while the MATRIX-12 is comparing.
Attempting to use the knobs and buttons in the PAGE MODIFIER section
for purposes of editing will have no effect and the controls will appear to
have gone dead.
170 Matrix-12 Owner's Manual

Oberheim Matrix-12 Specifications

General

Brand	Oberheim
Model	Matrix-12
Category	Synthesizer
Language	English