Oberheim Matrix-12 - Page 167

As an example, if Voices 1 and 2 are selected, changing Banks selects
Voices 7 and 8. Voices 1 and 2 will retain their settings but are no longer
selected because 7 and 8 are now being displayed. Performing edits
affects only those Voices being displayed.
Patch/Voice Editing
There will be times when the sound of one or more of the SINGLE Patches
used in a MULTI Patch will need to be edited. As an example, you may
decide that a particular Patch would sound better in the MULTI Patch if it
just had a few changes made. It is possible to edit a SINGLE Patch while it
is in a MULTI Patch.
To edit a patch for one Voice:
1. Press the PATCH EDIT button of the Voice that contains the
patch you want to change so that it becomes underlined. This
actually enters SINGLE PATCH Mode for this Voice and
the PAGE MODIFIER will now display the SINGLE PATCH Pages for
the Patch assigned to this Voice.
2. All of the Single Patch Edit Pages under the front panel heading
SINGLE/MULTI PATCH PAGE SELECT are now active so that the
actual sound of this patch can be edited because the MATRIX-12
has effectively entered SINGLE PATCH Mode for this Voice alone.
You can now make whatever changes to the Patch that you want.
3. After you have made any changes to the Patch, you can compare
this edited Patch in the MULTI Patch with its original, unedited
version. Just press its PATCH EDIT button and the original version
is recalled from memory. Its Patch Number will flash off and on to
remind you that you are Comparing.
4. Your edits to this Patch can be programmed into memory as well,
but this will also affect this Patch in SINGLE PATCH Mode. Make
sure that the MEMORY PROTECT switch on the MATRIX-12's back
panel is switched to its OFF position. Press and hold the red
STORE button. While you are holding it, type in the 2-digit Patch
number on the Keypad. Again, please keep in mind that if this
function is performed, you will have also permanently
edited this particular patch in its SINGLE Patch location
as well.
NOTE: In general, performing the STORE function operates on whatever is
underlined. If a SINGLE Patch Number-either a Patch in SINGLE
Mode or a SINGLE Patch within a MULTI Patch - is underlined, the
newly entered SINGLE Patch will replace whatever is in memory for that
Patch.
Matrix-12 Owner's Manual 167