Oberheim Matrix-12 - Page 78

ABORTED
The data transfer routine was stopped before completion. Did you
accidentally press the PAGE 2 button while the tape transfer was still in
progress?
ERROR IN SINGLE PATCH DATA
The MATRIX-12 detected one or more errors in the SINGLE Patch data.
ERROR IN MULTI PATCH DATA
The MATRIX-12 detected one or more errors in the MULTI Patch data.
ERROR IN CHAIN DATA
The MATRIX-12 detected one or more errors while loading the Patch
CHAIN
ERROR IN GLOBAL DATA
The MATRIX-12 detected one or more errors while loading the Global
data in MASTER PAGE.
WRONG VERSION NUMBER
The MATRIX-12 is unable to read the incoming data because it was
made from another MATRIX-12 with an updated software version. To
correct this problem, you will need a software revision to make your
synthesizer and that particular tape compatible. You should contact
your nearest Authorized Oberheim Service Center for prices and
availability. As bng as you make and load tapes from the same
MATRIX-12 - or another MATRIX-12 with the same software - this error
will not occur.
NOT A MATRIX-12 TAPE
The MATRIX-12 is unable to recognize any of the data. This may be
due to either recording the data at too high a volume or playing it back
at too high a volume. Either of these two situations will cause the data
to be distorted. Another possibilty that would cause this error is
attempting to load in a tape made on another device such as a drum
machine, for example.
CASSETTE SPEED TOO SLOW
The cassette speed is too slow. Are your batteries getting low? If you
have a speed control on your cassette recorder, was it accidentally
changed?
CASSETTE SPEED TOO FAST
The cassette speed is too fast. Did you put in fresh batteries since this
tape was made? If you have a speed control on your cassette recorder,
was it accidentally changed?
DATA COMPLETE
100 Hits, 100 Runs, no Errors.
78 Matrix-12 Owner's Manual