Oki MICROLINE MX Series - Page 391

Index
391
Line Terminator, 264
LPI Adjust, 265
Max Line Width, 263
Page L./Inches, 266
Page L./Lines, 265
Page Length Rep, 263
Perforation Skip, 264
Primary Char. Set, 263
PTX Linefeed, 265
Reset Cmd CFG Ld, 266
Second Char. Set, 263
Symbol Set Print, 266
Perforation Skip, PCL-II Emulation, 264
PGL SFCC, 75, 131
PI Control, 161
Host PI, 162
Max PI 16, 162
Printer PI, 161
PI Ignored
Centronics (Parallel) submenu, 90
Dataproducts (Standard & Long Lines)
submenu, 93
PI Slew Range, 132
PLAT INV CMD * message, 334
PLAT INV PARM * message, 334
PLAT INV STATE * message, 334
PLEASE WAIT...RESET IN PROGRESS
message, 335
Plot Mode Opt, LG Emulation, 273
PMD (Paper Motion Detection) Fault,
ADVANCED USER, 281
Poll Character, Serial submenu, 102
Poll Response, Serial submenu, 102
Port Type, Auto Switching submenu, 85
Pos. on BC/OvrSz, ANSI Emulation
menu, 253
Position Aft FF (4234 only), 174, 190
Power Consumption, 348
Power On IGP/PGL, 134
Power requirements, 19
POWER SAVER MODE message, 335
Power Saver Time, ADVANCED
USER, 285
Power Stacker, ADVANCED USER
menu, 282
POWER SUPPLY HOT * message, 335
Power Up ^ F, 152
Power Up ^ X, 152
Power Up ^PY, 152
Powering on the printer, 25
Power-on S-Mode, 141
Power-Up Config, 79
Power-Up Config., 81
Power-Up State, MAINT/MISC menu, 281
PREV + NEXT key, 30
PREV or NEXT key, 30
Primary Char. Set, PCL-II Emulation, 263
Prime Signal
Centronics (Parallel) submenu, 91
Dataproducts (Standard & Long Lines)
submenu, 94
IEEE 1284 Parallel (Bidirectional)
Submenu, 87