175
EN
Shooting Settings
4
Recording pictures with varied white balance (WB BKT)
PASMB
n
The camera varies white balance to record a series of pictures. You choose the color
axis and the bracketing amount.
Shooting ends after a single shot. The camera takes one picture when the shutter
button is pressed all the way down and automatically processes it to record the
pictures.
Menu
MENU n
‘
n3. Bracketing n WB BKT
A-B
Select the bracketing amount for the A-B (amber–blue) axis.
[O] / [3f 2Step] / [3f 4Step] / [3f 6Step]
G-M
Select the bracketing amount for the G-M (green–magenta) axis.
[O] / [3f 2Step] / [3f 4Step] / [3f 6Step]
Three pictures are created for each color axis.
The rst copy is recorded at current white balance settings, the second using a
negative value for compensation, and the third using a positive value.
• If white balance ne-tuning is enabled before shooting begins, the camera will vary white
balance around the selected value.
# White balance bracketing cannot be combined with art lter bracketing (P. 177) or focus
bracketing (P. 178).
Recording pictures with varied ash level (FL BKT)
PASMB
n
The camera varies ash level (output) over a series of shots. You choose the amount
of variation. The camera takes a shot at a new ash level each time the shutter button
is pressed all the way down. Bracketing ends after the required number of shots has
been taken. In burst shooting modes, the camera will take pictures while the shutter
button is pressed all the way down, ending when the required number of shots has
been taken.
Menu
MENU n
‘
n3. Bracketing n FL BKT
O Pictures are taken without using this function.
3f 0.3EV 3 pictures are taken with the bracketing amount of 0.3 EV.
3f 0.5EV 3 pictures are taken with the bracketing amount of 0.5 EV.
3f 0.7EV 3 pictures are taken with the bracketing amount of 0.7 EV.
3f 1.0EV 3 pictures are taken with the bracketing amount of 1.0 EV.
“BKT” is displayed in green until all the shots in the bracketing sequence have been
taken. The rst shot is taken at current ash settings, followed rst by the shot with
reduced ash output and then by the shot with increased ash output.
%If you change the [EV Step] setting (P. 107), the bracketing amount of ash also
changes.
• If ash compensation is enabled before shooting begins, the camera will vary ash output
around the selected value.
# Flash bracketing cannot be combined with exposure bracketing (P. 174) or focus
bracketing (P. 178).
To Next Page
Loading...
Need help?
General
