296
EN
Information
10
Charging the battery in the power battery holder
To charge the battery in the power battery holder, load a battery in the holder and
attach the holder to the camera. Charge the battery in the same way as described on
P. 22. The charge lamp of the holder lights during charging.
Using the buttons
Slide the vertical shooting lock of the HLD-10 in the
direction of the arrow. The roles performed by the F
(Exposure compensation) button, ISO button and AF-ON
button on the HLD-10 can be selected using the [Button
Settings] item. g “Changing the roles of buttons (Button
Settings)” (P. 208)
# Buttons on the HLD-10 cannot be used when the vertical
shooting lock is in the LOCK position.
Notes on using this product
• Use only the designated battery. Failure to do so could result in injury, damage to the
product, and re.
• Do not use your nail to turn the attachment wheel. Doing so could result in injury.
• Only use the camera within the guaranteed operating temperature range.
• Do not use or store the product in dusty or humid areas.
• Do not touch the electrical contacts.
• Use a dry, soft cloth to clean the terminals. Do not clean the product with a damp cloth,
thinner, benzine, or any other organic solvents.
• Remove the batteries from the camera and power battery holder before putting the
camera into storage for periods of a month or more. Leaving the batteries in the camera
for extended periods shortens their lives, potentially rendering them unusable.
To Next Page
Loading...
