To Next Page

To Previous Page

308

Information

Functions that cannot be selected from menus

When you open the menu, items that cannot be set are displayed in gray.

If you press the Q button while selecting a gray item, the reason it cannot be set will be

displayed.

Refer to the on-screen instructions and check the settings (P. 65).

Functions that cannot be set from the super control panel

Some functions may be unavailable depending on the current shooting settings. Check if the

same function is displayed in gray in the menus (P. 65).

The subject appears distorted

The following functions use an electronic shutter:

movie recording (P. 59), silent mode (P. 132), Pro Capture shooting (P. 133), High

Res Shot (P. 156), focus bracketing (P. 178), focus stacking (P. 160), the live ND lter

(P. 158), HDR (P. 162)

This may cause distortion if the subject is moving rapidly or the camera is moved abruptly.

Avoid moving the camera abruptly during shooting or use standard sequential shooting.

Lines appear in photographs

The following functions use an electronic shutter, which may result in lines due to icker and

other phenomena associated with uorescent and LED lighting, an e󰀨ect that can sometimes

be reduced by choosing slower shutter speeds:

movie recording (P. 59), silent mode (P. 132), Pro Capture shooting (P. 133), High

Res Shot (P. 156), focus bracketing (P. 178), focus stacking (P. 160), the live ND lter

(P. 158), HDR (P. 162)

Flicker can be reduced by choosing slower shutter speeds. You can also reduce icker using

icker scan. g [KFlicker Scan], [nFlicker Scan] (P. 108)

Only the subject is displayed and no information is shown

The display has been switched to [Image Only]. Press the INFO button and switch to

another display mode.

Focus mode cannot be changed from MF (manual focus)

The lens you are using may be equipped with the MF clutch mechanism. In this case, manual

focus is selected when the focus ring is slid to the camera body side. Check the lens.

g “MF Clutch Lenses” (P. 292)

Nothing is displayed on the monitor

When something, e.g. your face, hand or strap, comes close to the viewnder, the monitor

turns o󰀨 and the viewnder turns on.

g “Switching between displays” (P. 37)

Olympus OM System OM-1 User Manual

Questions and Answers: