Olympus SLIDEVIEW VS200 User Manual

9 Unboxing
The units described below must be assembled and adjusted by Olympus. If these units are
assembled or adjusted by the customer, the operations are not ensured.
9.1 VS200 Scanner
The units described below must be assembled and adjusted by Olympus. If these units are
assembled or adjusted by the customer, the operations are not ensured.
9.1.1 Mounting of handles - VS200 scanner
The units described below must be assembled and adjusted by Olympus. If these units are
assembled or adjusted by the customer, the operations are not ensured.
CAUTION
Risk of injury and risk of device damage if components are dropped
The scanner or other components might drop when you are moving them.
Injury to your feet or damage to the device can result.
Make sure that all handles for transportation are screwed in completely and
tight.
The system must be carried by two people.
Two people are required to lift the system onto a table
1. Mount the four handles (2 on each side) like in the image below.
2. Lift the system with two persons onto a stable table. The main center of
gravity is at the back of the system.
3. Make sure that there is a gap of 30cm between the backside of the system
and the wall.
9.2 Transportation locks for the VS200 scanner
The units described below must be assembled and adjusted by Olympus. If these units are
assembled or adjusted by the customer, the operations are not ensured.
- 26 -
Instructions for use
9 Unboxing
OLYMPUS VS200 System

Olympus SLIDEVIEW VS200 Specifications

General

Brand	Olympus
Model	SLIDEVIEW VS200
Category	Microscope
Language	English