17 VS200 ASW software setup
The units described below must be assembled and adjusted by Olympus. If these units are
assembled or adjusted by the customer, the operations are not ensured.
This chapter describes the installation of VS200 ASW on a VS200 system PC.
1. Turn on the PC.
2. To start the setup process, go to D:\OLYMPUS_SERVICE_ONLY_DO_NOT_
DELETE\SetupMain\ and run the Setup.exe.
3. Click [Yes] to allow changes to the PC device.
4. Select the [Install or maintain imaging software] option and proceed with
[Next].
- 78 -
Instructions for use
17 VS200 ASW software setup
OLYMPUS VS200 System
To Next Page
Loading...
Need help?
General
