Transportation lock (1)
ATTENTION
The transportation locks must be remounted each time before the unit is trans-
ported. Make absolutely sure not to lose the transportation locks and the
mounting material.
Hex screwdriver (size 3mm)
1. Remove the red transportation lock from the VS200 loader’s tray hotel. To
do so, loosen the 4 hex screws (size 3 mm) indicated in the figure.
9.4.2 Removing transportation lock from SCARA robot arm
The units described below must be assembled and adjusted by Olympus. If these units are
assembled or adjusted by the customer, the operations are not ensured.
- 34 -
Instructions for use
9 Unboxing
OLYMPUS VS200 System
To Next Page
Loading...
Need help?
General
