Configuring an observation method
1. Select an observation method (e.g. CY3) in the [Name] list. This list con-
tains all of the observation methods that have already been defined.
2.
Click the [Copy Observation Method] button to create a copy of the
observation method.
3. Enter a name for the observation method in the [Enter a New Observation
Method Name] dialog box.
4. In the [Available Components] list select the [Fluorochromes] entry.
5. Select the [Use] entry from the [Status] list.
6. In the [Fluorochrome] list select the fluorochrome that fits to your new filter
combination.
7. In the [Available Components] list select the [ODB U-FFWO] entry.
8. Select the new filter you have added.
9. Do the same if you e.g. added a new excitation filter for the ODB U-FFWR
or a new IX3 filter cube in the IX3 Mirror Turret.
10. Click [OK] to save the changes.
11. As you created a new observation method you now have to carry out the
- 96 -
Instructions for use
18 VS200 device configuration
OLYMPUS VS200 System
To Next Page
Loading...
Need help?
General
