Omron CJ - 08-2008 - Page 347

299
PLC Setup Section 7-1
Format: Stop Bits
Format: Parity
Baud Rate (bps)
Unit Number (for CPU Unit in Host Link Mode)
Programming
Console address
Settings Function Related
flags and
words
When set-
ting is read
by CPU Unit
Word Bit(s)
+160 2 0: 2 bits
1: 1 bit
Default: 0
These settings are valid only when the com-
munications mode is set to host link or no-
protocol.
These settings are also valid only when the
RS-232C Port Settings Selection is set to 1:
PLC Setup.
A61902
(RS-232C
Port Settings
Changing
Flag)
At the next
cycle.
Programming
Console address
Settings Function Related
flags and
words
When set-
ting is read
by CPU Unit
Word Bit(s)
+160 0 to 1 00: Even
01: Odd
10: None
Default: 00
These settings are valid only when the com-
munications mode is set to host link or no-
protocol.
These settings are also valid only when the
RS-232C Port Settings Selection is set to 1:
PLC Setup.
A61902
(RS-232C
Port Settings
Changing
Flag)
At the next
cycle.
Programming
Console address
Settings Function Related
flags and
words
When set-
ting is read
by CPU Unit
Word Bit(s)
+161 0 to 7 00: 9,600 bps
01: 300 bps
02: 600 bps
03: 1,200 bps
04: 2,400 bps
05: 4,800 bps
06: 9,600 bps
07: 19,200 bps
08: 38,400 bps
09: 57,600 bps
0A: 115,200 bps
Default: 00
These settings are valid only when the com-
munications mode is set to host link or no-
protocol.
These settings are also valid only when the
RS-232C Port Settings Selection is set to 1:
PLC Setup.
A61902
(RS-232C
Port Settings
Changing
Flag)
At the next
cycle.
Programming
Console address
Settings Function Related
flags and
words
When set-
ting is read
by CPU Unit
Word Bit(s)
+163 0 to 7 00 to 1F:
(0 to 31)
Default: 00
This setting determines the CPU Unit’s unit
number when it is connected in a 1-to-N
(N=2 to 32) Host Link.
A61902
(RS-232C
Port Settings
Changing
Flag)
At the next
cycle.