329
PLC Setup Section 7-1
7-1-2-14 Origin Return Function
The following tables show the settings for the origin return function in the CX-
Programmer. These settings are for CJ1M CPU Units equipped with the built-
in I/O functions.
Pulse Output 0 Settings
Note CX-Programmer Tabs
CX-Programmer Ver. 3.1 or lower: Define Origin Operation Settings Field of
Define Origin 1
CX-Programmer Ver. 3.2 or higher: Pulse Output 0
Pulse Output 0 Origin Search/Return Initial Speed
Note When the CX-Programmer is being used to make the setting, the setting is
input in decimal.
Speed (Target Speed for Pulse Output 0 Origin Return)
Note When the CX-Programmer is being used to make the setting, the setting is
input in decimal.
Programming
Console
address
Settings Default Function Related
Auxiliary
Area flags/
bits
Time when
setting is read
by CPU Unit
Word Bits
+258 00 to 15 00000000 to
000186A0 hex
(See note.)
00000000
hex
Specifies the starting speed (0 to
100,000 pps) for the pulse output 0
origin search and origin return opera-
tions.
--- When operation
starts
+259 00 to 15
Programming
Console
address
Settings Default Function Related
Auxiliary
Area flags/
bits
Time when
setting is read
by CPU Unit
Word Bits
+270 00 to 15 00000001 to
000186A0 hex
(See note.)
00000000
hex
Specifies the target speed (1 to
100,000 pps) for pulse output 0 origin
return operation.
--- When operation
starts
+271 00 to 15
To Next Page
Loading...
