Omron CJ - 08-2008 User Manual

504
Error Processing Section 11-2
1. The rack number will be given at *.
2. The FAL/FALS number will be given at ***.
3. The unit number will be given at **.
4. The master number will be given at *.
MEMORY ERR *
I/O BUS ERR
UNIT NO. DPL ERR
RACK NO. DPL ERR
TOO MANY I/O PNT
I/O SET ERR
PROGRAM ERR
CYCLE TIME ERR
SYS FAIL FALS
SYS FAIL FAL ***
INTRPT ERR
DENSITY I/O ERR
PC SETUP ERR
CPU BU ERR **
SIOU ERR **
BAT LOW
CPU BU STUP **
SIOU SETUP **
Fatal error
Memory error
I/O bus error
I/O Table
Setting error
Program error
Non-fatal error
Interrupt
Task error
Battery error
(See note 1.)
(See note 2.)
(See note 3.)
(See note 3.)
(See note 3.)
(See note 3.)
FAL error
Unit Number
Duplication
error
Rack Number
Duplication
error
Too Many I/O
Points error
Cycle Time
Overrun error
System FALS
error
Special I/O
Unit Setup
error
CJ1 CPU
Bus Unit
Setup error
Special I/O
Unit error
CJ1 CPU Bus
Unit error
PLC Setup
error
Basic I/O
error
(See note 2.)

Omron CJ - 08-2008 Specifications

General

Brand	Omron
Model	CJ - 08-2008
Category	Controller
Language	English