Omron NX-EIC202 - Attaching Markers

6 Installation
6 - 18
NX-series EtherNet/IP Coupler Unit User’s Manual (W536)
Markers can be attached to EtherNet/IP Coupler Units, NX Units, and terminal blocks on NX Units to
identify them.
The plastic markers made by OMRON are installed for the factory setting. The ID information can be
written on them.
Commercially available markers can also be installed.
Replace the markers made by OMRON if you use commercially available markers now.
 Installation Method
Insert the protrusions on the markers into the marker attachment locations on the EtherNet/IP Cou-
pler Units, NX Units, and terminal blocks on NX Units.
6-1-8 Attaching Markers
a
b
Flat-blade screwdriver
1)
2)
Markers
Marker
Marker
Marker attachment location
Marker attachment location
<Terminal block><Units>