Omron NX-EIC202 - Troubleshooting; 12-1 How to Check for Errors; 12-2 Checking for Errors and Troubleshooting with the Indicators; 12-3 Checking for Errors and Troubleshooting with Support Software

12 - 1
12
NX-series EtherNet/IP Coupler Unit User’s Manual (W536)
There are several ways to check errors on an EtherNet/IP Slave Terminal. If an error
occurs, refer to this section to troubleshoot the error.
12-1 How to Check for Errors . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12-2
12-2 Checking for Errors and Troubleshooting with the Indicators . . . . . . . . 12-3
12-2-1 Checking for Errors and Troubleshooting with
the Indicators on the EtherNet/IP Coupler Unit . . . . . . . . . . . . . . . . . . . . . . . . 12-3
12-2-2 Checking for Errors and Troubleshooting with
the Indicators on the NX Units . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12-9
12-3 Checking for Errors and Troubleshooting with Support Software . . . . 12-10
12-3-1 Checking Status with the Network Configurator . . . . . . . . . . . . . . . . . . . . . . 12-10
12-3-2 Connection Status Codes and Troubleshooting . . . . . . . . . . . . . . . . . . . . . . 12-17
12-3-3 Checking for Errors from the Sysmac Studio . . . . . . . . . . . . . . . . . . . . . . . . 12-21
12-3-4 Checking for Errors from Support Software
Other Than the Sysmac Studio . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12-21
12-3-5 Event Codes for Errors and Troubleshooting Procedures . . . . . . . . . . . . . . 12-22
12-4 Resetting Errors . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12-51
12-4-1 Procedure to Reset Errors . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12-51
12-5 Troubleshooting Other Errors . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12-54
Troubleshooting