Omron NX-EIC202 - Setting IP Address; Directly Setting the IP Address with the Network Configurator

9 - 31
9 Setting Up Slave Terminals
NX-series EtherNet/IP Coupler Unit User’s Manual (W536)
9-4 Setting IP Address
9
9-4-1 Directly Setting the IP Address with the Network Configurator
9-4 Setting IP Address
There are several ways to set the IP address of the Slave Terminal. Specify the IP address setting
method as follows with the rotary switches.
Precautions for Correct Use
Use the following methods to check the IP address of the Slave Terminal.
• Check with a combination of the DIP switch (pin 4) and rotary switches.
• Use attached information 1 for IP Address Fixed in the event log.
Version Information
Getting an IP address from the BOOTP server is supported from NX-EIC202 version 1.2 or
later.
Use the Network Configurator to directly set the IP address. The setting procedure is as follows.
1 Set both rotary switches to 0x0 and power on the EtherNet/IP Coupler Unit. The EtherNet/IP
Unit will have the default IP address 192.168.250.1 (DIP switch 4 is OFF) or 192.168.1.1 (DIP
switch 4 is ON).
Refer to 4-3 Hardware Switch Settings on page 4-8 for more information.
2 Connect the Network Configurator online.
Set value (hex) IP address setting method
00 • Directly set the IP address with the Network Configurator.
• Specify getting the IP address from the BOOTP server with the Network Configu-
rator.
01 to FE Directly set the IP address using hardware switches.
FF Specify getting the IP address from the BOOTP server.
9-4-1 Directly Setting the IP Address with the Network Configurator