Omron NX-EIC202 - Page 414

Appendices
A - 68
NX-series EtherNet/IP Coupler Unit User’s Manual (W536)
The following describes the relationship between the unit versions of the EtherNet/IP Coupler Units, the
unit versions of the CS/CJ/CP-series CPU Units, and the versions of the Support Software.
 CS1G/CS1H/CJ1H/CJ1M CPU Units
 CJ2H-CPU6/CJ2M-CPU1/CP1H CPU Unit
 CJ2H-CPU6-EIP CPU Unit
*1. The CX-ConfiguratorFDT with version 2.2 or later can be used if it is connected to the peripheral USB port
on the EtherNet/IP Coupler Unit.
Connection to CS/CJ/CP-series CPU Unit
EtherNet/IP Coupler Unit Corresponding unit version/version
Model
Unit ver-
sion
Unit version
of CPU Unit
Unit version
of
CS1W-EIP21
/CJ1W-EIP2
1
Network
Configura-
tor for Eth-
erNet/IP
version
NX-IO Con-
figurator
version
CX-Configu-
ratorFDT
version
NX-EIC202 Ver.1.2 Ver.3.0 Ver.2.1 Ver.3.00 Ver.1.00
Ver.2.4
*1
*1. The CX-ConfiguratorFDT with version 2.2 or later can be used if it is connected to the peripheral USB port
on the EtherNet/IP Coupler Unit.
Ver.1.0
Ver.1.00
*2
*2. You can connect only to the peripheral USB port on the EtherNet/IP Coupler Unit. You cannot connect with
any other path.
Ver.2.2
EtherNet/IP Coupler Unit Corresponding unit version/version
Model
Unit ver-
sion
Unit version
of CPU Unit
Unit version
of
CJ1W-EIP21
Network
Configura-
tor for Eth-
erNet/IP
version
NX-IO Con-
figurator
version
CX-Configu-
ratorFDT
version
NX-EIC202 Ver.1.2 Ver.1.0 Ver.2.1 Ver.3.00 Ver.1.00
Ver.2.4
*1
*1. The CX-ConfiguratorFDT with version 2.2 or later can be used if it is connected to the peripheral USB port
on the EtherNet/IP Coupler Unit.
Ver.1.0
Ver.1.00
*2
*2. You can connect only to the peripheral USB port on the EtherNet/IP Coupler Unit. You cannot connect with
any other path.
Ver.2.2
EtherNet/IP Coupler Unit Corresponding unit version/version
Model
Unit ver-
sion
Unit version
of CPU Unit
Unit version
of
CJ1W-EIP21
Network
Configura-
tor for Eth-
erNet/IP
version
NX-IO Con-
figurator
version
CX-Configu-
ratorFDT
version
NX-EIC202 Ver.1.2 Ver.1.5 Ver.2.1 Ver.3.00 Ver.1.00
Ver.2.4
*1
*1. The CX-ConfiguratorFDT with version 2.2 or later can be used if it is connected to the peripheral USB port
on the EtherNet/IP Coupler Unit.
Ver.1.0
Ver.1.00
*2
*2. You can connect only to the peripheral USB port on the EtherNet/IP Coupler Unit. You cannot connect with
any other path.
Ver.2.2