Omron SYSDRIVE 3G3JV - Page 176

7-51
D Inverter Control Output (Register 002C Inverter Status)
Word Slave 1 function Word Slave 2 function Word Slave 3 function
001100 During RUN 001200 During RUN 001300 During RUN
001101 Zero speed 001201 Zero speed 001301 Zero speed
001102 Frequency agree 001202 Frequency agree 001302 Frequency agree
001103 Warning (Nonfatal error) 001203 Warning (Nonfatal error) 001303 Warning (Nonfatal error)
001104 Frequency detection 1 001204 Frequency detection 1 001304 Frequency detection 1
001105 Frequency detection 2 001205 Frequency detection 2 001305 Frequency detection 2
001106 Inverter ready 001206 Inverter ready 001306 Inverter ready
001107 UV 001207 UV 001307 UV
001108 Base block 001208 Base block 001308 Base block
001109 Frequency reference
mode
001209 Frequency reference
mode
001309 Frequency reference
mode
001110 RUN command mode 001210 RUN command mode 001310 RUN command mode
001111 Overtorque detection 001211 Overtorque detection 001311 Overtorque detection
001112 0 (Not used.) 001212 0 (Not used.) 001312 0 (Not used.)
001113 Fault retry 001213 Fault retry 001313 Fault retry
001114 Fault 001214 Fault 001314 Fault
001115 Communications time-
over
001215 Communications time-
over
001315 Communications time-
over
D Area Used by Operand of PMCR Instruction
The area used by the operand of the PMCR instruction with CS-series PCs is shown below.
• Control Data: C1
Area
Communications
port 7 selected
Serial port 2
selected
Communications Board
selected (E1)
• Control Data: C2
Area
Sequence 000 set
Communications Chapter 7