2-13
D Selecting Sequence Input Method
• By using SW7, NPN or PNP input can be selected as shown below.
24 V DC
(±10%)
S1 to 5
S1 to 5
D Selecting Frequency Reference Input Method
• By using SW8, frequency reference voltage or current input can be selected.
Parameter settings are required together with the selection of the frequency reference input method.
Frequency reference input
method
SW8 setting Frequency reference selection
(parameter n03)
Voltage input V (OFF) Set value 2
Current input I (ON) Set value 3 or 4
Design Chapter 2
To Next Page
Loading...
