OnRobot Eyes - 3.6. Best practices - HEX-E;H QC

Connect the supplied power supply to the Eye Box 24V
connector.
NOTE:
To disconnect the power connector,
make sure to pull the connector housing
(where the arrows are shown) and not
the cable.
CAUTION:
Use only original OnRobot power
supplies. The Eye Box requires minimum
120W.
Finally, power up the power supply that will power the Eye Box and the connected Tool(s).
3.6. Best practices - HEX-E/H QC
Best practices to maintain the calibrated device:
•
Power
o the HEX sensor when it is not used for a longer period of time.
•
Remove any dead weight from the sensor when it is not used for a longer period of time.
HW INSTALLATION
23