The Auto-calibration limit has been reached. Further
Auto-calibration is not possible. The HEX sensor should
work correctly but it is inside a range where we
recommend an OnRobot factory recalibration within the
coming months. Please see User Manual under Auto-
calibration for details.
8. Re-attach the tool(s) to the sensor the same way as it was.
9. Start your robot and validate your application.
10. Auto-calibration is
finished.
Considerations for the auto-calibration:
•
It is recommended to make an auto-calibration every 2-3 months.
•
If the auto-calibration process detects that an OnRobot factory re-calibration is needed,
schedule your sensor to be sent back to the OnRobot factory for a re-calibration within the
coming months.
6.1.3.3. VG10 / VGC10
ADDITIONAL SOFTWARE OPTIONS
154
To Next Page
