OnRobot Eyes - Page 87

•
Try once: The Eyes Inspect command will try only one time.
•
Try for (s): The user can input how long in seconds the Eyes Inspect command will try to
locate workpieces.
•
Try forever: The Eyes Inspect command will never stop trying to locate workpieces.
One shot detection
If enabled, the Eyes will attempt to identify all target workpieces at once saving their pose and
type. The section of the task inside the Eyes Locate node will execute as many times as
workpieces were detected by the Eyes. In this way, it is possible to handle all workpieces
without acquiring more images and thus, reducing cycle time.
Camera View Pose
If enabled, Eyes Locate will move the robot to the associated camera view pose of the
selected task. This camera view pose is saved while creating the camera view for the
application. The move applied is a joint move. Joint Speed and Joint Acceleration can be
adjusted.
Pick Oset Edit
A new page with the Pick Oset setting will be shown by pressing on .
Pick Oset
In the first dropdown menu, the user can select which workpiece's pick osets and rotation
will be edited. If the picking position of the workpiece is placed inside the region of interest,
picking position and axes are visualized in the overlay. Axes X, Y, Z are represented by lines
OPERATION
87