OPHIR BeamSquared - 1.5 Software Information

Software Information 1.5
BeamSquared is designed to measure the propagation characteristics of UV, VIS, NIR, and extended NIR laser
beams. For questions related to BeamSquared or compatible accessories, contact Ophir-Spiricon’s service
department (service@us.ophiropt.com).
Manual users can also measure THz laser beams in manual mode with a Pyrocam IV or IIIHR.
If you are using a camera that was purchased with a BeamGage system the camera should be
returned to the factory to determine if it is suitable for automated beam propagation measurements.
BeamSquared measures propagation characteristics in both the X and Y axes and displays the following
parameters:

Waist diameters

Full angle divergences

Waist locations

Rayleigh lengths

M
2
or K and BPP factor

Astigmatism

Asymmetry
BeamSquared employs Ultracal to achieve the highest possible measurement accuracy.
Automated BeamSquared Required Equipment:

A PC computer running Windows 7 or Windows 10

BeamSquared hardware

A SP300, SP920, or XC-130 camera

A laser beam attenuation device
Automated BeamSquared Optional accessories:

One pair of beam steering mirrors
Manual BeamSquared Required Equipment:

A PC computer running Windows 7 or Windows 10

A Pyrocam IV or III
HR
camera

A beam-focusing element with known focal length

A laser beam attenuation device

A beam block to shield the camera during calibration

An optical rail or other means of accurately positioning the camera with relationship to the
focusing element
PC Specifications

A personal computer running Windows 7 or Windows 10 64 bit operating system.

For best performance:
o
Graphics card with 1GB dedicated memory or Intel Processor Graphics Core i3 or better
o
At least 8GB of main memory
o
At least 50GB of hard disk space available
o
A high-resolution color monitor, 1920x1080 minimum recommended