Oracle ZFS Storage Appliance Service Manual

Replacing a 7x20 DIMM
6.
Slide the power supply into the bay until it is fully seated. The following figure
shows the 7420 power supply.
7.
Connect the power cord to the power supply.
8.
Verify that the green AC Present status indicator is lit.
9.
Close the CMA, inserting the CMA into the rear left rail bracket.
10.
Go to the Maintenance > Hardware screen of the BUI. Click the right-arrow icon
for the controller and then click PSU to verify that the online icon is green
for the newly installed power supply.
11.
If a fault does not self-clear, see “Repairing Active Problems” on page 37.
Replacing a 7x20 DIMM
Caution - This procedure requires that you handle components that are sensitive to static
discharge, which can cause the component to fail. To avoid damage, wear an antistatic wrist
strap and use an antistatic mat when handling components.
184 Oracle ZFS Storage Appliance Customer Service Manual • July 2016

Oracle ZFS Storage Appliance Specifications

General

Connectivity	10GbE, 40GbE, InfiniBand, Fibre Channel
Protocols	NFS, SMB, iSCSI, Fibre Channel, HTTP
Operating System	Oracle Solaris
Data Protection	snapshots, clones, remote replication
Data Reduction	Inline compression, deduplication
High Availability	Redundant hardware components (controllers, power supplies, fans). Automatic failover between controllers. Hot-swappable drives and components. Cluster configurations for increased availability and scalability.
Management Interface	Web-based GUI, CLI, REST API
Storage Type	Hybrid (SSD + HDD), All-Flash
Storage Capacity	Up to several petabytes
Encryption	AES-256 encryption at rest