Panasonic CZ-CFUNC2

ー 123 ー
Operating Instructions Intelligent Controller
154
Conguring the system
Setting
6
Touch [Register].
z The “Edit area group settgs” dialogue closes. z To cancel the settings, touch [Cancel].
6
7
Put a check mark in the “Valid” column.
z Put a check mark in the area group to use.
7
8
Touch [Register].
z To cancel the settings, touch [Cancel].
8
The “Area group name settings” screen A: Put a check mark in the group to be edited. B: Put a check mark in the group name use the
area group.
C: The names of the indoor units belonging to the
selected area group are displayed.
D: The “Edit area group settgs” dialogue is
displayed when you touch this.
A B C
D
Changing the name of the area group
155
Conguring the system
Setting
Changing the name of the distribution group Edit the name of the distribution group.
4
Touch [Setng].
z The “Edit distribution group sttngs” dialogue is displayed.
4
5
Change the settings.
Item Explanation
Name Change the name of the distribution group.
You can enter up to 16 letters or numbers.
Display
Use
to set the order when displayed
in a list.
Continued on next page
1
Touch [System Settings] in “Settings”.
z The “System settings” screen is displayed.
1
2
Touch [Distribution group settings].
z The “Distribution group settings” screen is displayed.
2
3
Put a check mark in the “Select” column.
z Select the distribution group name to be edited.
3
TGR-318_ENG.indb 123 2017/04/06 10:44:13