176
Maintenance settings
Setting
Initialising the unit and setting log levels
Initialise the unit and set and admin number (password) and log output levels.
Initialising
1
Select the type of initialisation.
1
Item Explanation
@FctryShip All data (settings, accumulated data,
distribution data) is deleted.
ResetCumlDataFrToday The accumulated data for the day is
deleted. Use this after performing a test
operation of the air conditioning units, for
example.
2
Touch [Initialize].
z Several conrmation messages will be displayed, so touch
[Yes] each time.
z Initialisation starts.
z When initialising is complete, the message “Settings were
reset. IntelligntCtrlr is restarting...” is displayed.
2
1
Touch [IntelContrlr maint] in “Settings”.
z The “IntelContrlr maint” screen is displayed.
1
2
Touch [Initialize].
z The “Initialize” screen is displayed.
2
All data is deleted when you initialise.
Unless you are the administrator, do not initialise under any circumstances.
177
Maintenance settings
Setting
Set the log output level
Set a level for outputting the log data recorded in this unit.
The content of the log data output differs according to the log level
that is set.
1
Select the log level.
1
2
Touch [Chng].
z The setting is registered.
2
Setting admin numbers
Some menus require you to enter an admin number (password)
to perform settings and operations. There are two levels of admin
number (level 1 and level 2).
1
Enter an identication number for each
level.
z The touchscreen keyboard appears when you touch the
text box.
z Use an identication number of at least 8 numbers
(alphanumeric only).
1
2
Touch [Register].
z The setting is registered.
2
Initialising the unit and setting log levels
To Next Page
Loading...
