Panasonic FP Web-Server2 - PPP Communication Via Null Modem Cable

Dial-in setup for PPP server
142 FP Web-Server V2.810 EN
 FPWIN Pro settings to access Unit_2:
1
st
IP address: computer IP: 192.168.206.5
2
nd
IP address: destination Web-Server IP: 172.148.180.x
There are 3 IP sub-networks involved in this setup:
 133.254.83.x: Computer Ethernet (any IP except 192.168.206.x or
172.148.180.x)
 192.168.206.x: Computer + FP Web Modem (always use
192.168.206.x)
 172.148.180.x: FP Web Ethernet (any IP except 192.168.206.x or
133.254.83.x)
Comments:
 Additionally (and in parallel) the FP Web-Server (Gateway Unit_1) can
be set up to use the modem for Internet dialup and e-mail sending.
 For details on the PPP server settings of the FP Web-Server, refer to
configuration example for the FP Web-Server that implemented the PPP
server access (see p. 139).
14.1.6 PPP communication via null modem cable
PPP connections can also be used directly to connect the FP Web-Server via
the 9-pin serial port to a computer or an other device. As cable between
the units a null modem cable is needed.