Dial-out setup for PPP client
FP Web-Server V2.810 EN 147
5. In the "Dial-out (see p. 153)" tab, enable the option button "E-mail
triggered" and the check box "Dial-up Internet (modem at 9-pin
connector)"
6. Enter the telephone number for modem dial-up
If you use a PBX, set the string "0" or "0w" (with delay after first zero)
in front of the number.
7. Enter the login name and password for the dial-up account
The authentication method is normally set to "PAP".
8. Set a baud rate that complies with the modem used
The FP Web-Server always connects with the internal settings of 8 bits,
none parity and 1 stop bit.
9. Set the idle timeout
The idle timeout can be lowered to approx. 2 minutes (120s). After this
interval, if no data communication has occurred, the FP Web-Server
disconnects from the dial-up ISP and hangs up the modem connection.
For the settings on "Modem" or "Null modem cable", refer to the online help
under modem or null modem cable selection
For further settings, refer to the online help under the keywords "User modem
init command" and "Delay after init command".
To Next Page
Loading...
