Panasonic KX-TGP500 - Tone Settings; Dial_Tone_Frq; Dial_Tone_Timing; Busy_Tone_Frq

Value Range
• Y: Enable (Press the Hold button to transfer a call.)
• N: Disable (Press the Transfer button to transfer a call.)
Default Value
N
4.5.3 Tone Settings
DIAL_TONE_FRQ
Value Format Comma-separated Integer
Description Specifies the dual-tone
frequencies, in hertz, of dial tones using 2 whole
numbers separated by a comma.
Value Range 0, 200–1000 (0: No tone)
Note
• If
the value for this setting is "350,440", the unit will use a mixed
signal of a 350 Hz tone and a 440 Hz tone.
Default Value 350,440
Web User Interface Reference Tone Frequencies (Page 118)
DIAL_TONE_TIMING
Value Format Comma-separated Integer
Description Specifies the pattern, in milliseconds, of dial tones using 4 whole
numbers (on 1, off 1, on 2, off 2) separated by commas.
Value Range 0–5000 (0: Infinite time)
Note
• The
unit will play the tone for the duration of the first value, stop
it for the duration of the second value, play it for the duration of
the third value, and then stop it for the duration of the last value.
The whole sequence will then repeat. For example, if the value
for this setting is "100,100,0,0", the unit will play the tone for 100
ms, stop it for 100 ms, and then play it continuously.
Default Value 0,0,0,0 (The unit plays the dial tone continuously.)
Web User Interface Reference Tone Timings (Page 118)
BUSY_TONE_FRQ
Value Format Comma-separated Integer
Description Specifies the dual-tone frequencies, in hertz, of busy tones using 2
whole numbers separated by a comma.
Value Range 0, 200–1000 (0: No tone)
180 Administrator Guide Document Version 2013-02
4.5.3 Tone Settings