Default Value 2
Web User Interface Reference Minimum Delay (Page 100)
NOM_DELAY_[1–8]
Parameter Name Example NOM_DELAY_1, NOM_DELAY_2, …, NOM_DELAY_8
Value Format Integer
Description Specifies the initial delay, in 10-millisecond units, of the jitter buffer.
Value Range
1–7 (´ 10 ms)
Note
• This setting is subject to the following conditions:
– This value must be greater than or equal to
"MIN_DELAY"
– This value must be less than "MAX_DELAY"
Default Value 2
Web User Interface Reference Initial Delay (Page 100)
RTP_PORT_MIN
Value Format Integer
Description Specifies the lowest port number that the unit will use for RTP packets.
Note
• If port numbers are specified in [Channel 1–3] in
3.4.5.3 External RTP Port in the Web user interface, this
setting is ignored and the corresponding external RTP port is
enabled.
Value Range 1024–59598 (even number only)
Note
• The value for this setting must be less than or equal to
"RTP_PORT_MAX" - 400.
Default Value 16000
Web User Interface Reference Minimum RTP Port Number (Page 97)
RTP_PORT_MAX
Value Format Integer
190 Administrator Guide Document Version 2013-02
4.6.2 RTP Settings
To Next Page
Loading...
