Detection Interval
Description Specifies the interval, in seconds, to wait between attempts to detect
the global IP address.
Value Range 0, 10–65535 (0: Disable)
Note
• When [Detection
Method] is set to [SIP], the value "0" disables
detection and a value other than "0" enables detection.
Default Value 0
3.4.4.2 STUN Server
STUN Server Address
Description Specifies the IP address or FQDN of the STUN server.
Value Range Max. 127 characters
Default Value Not stored.
Configuration File Reference STUN_SERV_ADDR (Page 173)
STUN Server Port
Description Specifies the port number of the STUN server.
Value Range 1–65535
Default Value 3478
Configuration File Reference STUN_SERV_PORT (Page 174)
3.4.5 Static NAPT Settings
This screen allows you to configure the
NAPT (Network Address Port Translation) settings. If the unit is
connected behind a router that uses NAT/NAPT to translate private IP addresses, global IP addresses, VoIP
Document Version 2013-02 Administrator Guide 75
3.4.5 Static NAPT Settings
To Next Page
Loading...
