Panasonic KX-TGP500 - Programming via Web Interface; Activating and Using Embedded Web

5. [ ]/[ ]: Select "Authentication" ®
6. [ ]/[ ]: Select "ID" ®
7. Enter the Authentication ID (16 characters max.).
8.
To set Authentication Password
In cases when buttons/soft key icons are shown in English alphabet
1. Handset: [MENU] (center of joystick)
2. [ ]/[ ]: Select "IP Service" ® [SELECT]
3. [ ]/[ ]: Select "Call Features" ® [SELECT]
4. [
]/[ ]: Select "Settings" ® [SELECT]
5. [ ]/[ ]: Select "Authentication" ® [SELECT]
6. [ ]/[ ]: Select "Password" ® [SELECT]
7. Enter the Authentication Password (16 characters max.).
8. [SAVE]
In cases when buttons/soft key icons are shown in symbols/pictures
1. Handset:
(center of joystick)
2. [ ]/[ ]: Select "IP Service" ®
3. [ ]/[ ]: Select "Call Features
" ®
4. [ ]/[ ]: Select "Settings" ®
5. [ ]/[ ]: Select "Authentication" ®
6. [ ]/[ ]: Select "Password" ®
7. Enter the Authentication Password (16 characters max.).
8.
Notice
• After these parameters are set, phone will reboot automatically.
• If
you set above-mentioned ID or password by WEB User Interface, this menu is not displayed (® see
3.4.3.2 HTTP Authentication).
• The handset has Alphabet (ABC) and Numeric (0-9) entry mode. When in these entry modes, you can
select which character is entered by pressing the right soft key.
Alphabet character table for handset (ABC)
Numeric entry table (0-9)
2.1.8 Access Code
Enter the access code for provisioning specified by the carrier according to the following operations.
Document Version 2013-02 Administrator Guide 41
2.1.8 Access Code