To access the Web user interface
1. Open
your Web browser, and then enter "http://" followed by the unit’s IP address into the address field of
your browser.
Note
• To determine the unit’s IP address, perform the following operations on the base unit
(KX-TGP55x only) or handset:
In cases when buttons/soft key icons are shown in English alphabet
1. Base unit: [MENU] (middle soft key) ® [#][5][0][1]
Handset: [MENU] (center of joystick) ® [#][5][0][1]
2. Base unit: [EXIT]
Handset: [OFF]
In cases when buttons/soft key icons are shown in symbols/pictures
1. Base unit:
(middle soft key) ® [#][5][0][1]
Handset: (center of joystick) ® [#][5][0][1]
2. Base unit: [ ]
Handset: [ ]
2. For authentication, enter your ID (username) and password, and then click OK.
Notice
• The
default ID for the User account is "user", and the default password is blank. The ID cannot be
changed from the Web user interface, but it can be changed through configuration file
programming.
• When you log in as User to the Web user interface for the first time, the [Change User
Password] screen (® see 3.5.3 Change User Password) will be displayed. Enter a new
password, and then perform authentication again with the new password to log in to the Web user
interface.
• The default ID for the Administrator account is "admin", and the default password is "adminpass".
The ID cannot be changed from the Web user interface, but it can be changed through configuration
file programming.
3. The Web user interface window is displayed. Configure the settings for the unit as desired.
4. You can log out from the Web user interface at any time by clicking [Web Port Close].
Document Version 2013-02 Administrator Guide 55
3.2.2 Accessing the Web User Interface
To Next Page
Loading...
