12. Others
322
• If [Focus/Release Priority] is set to [FOCUS], then recording will not take place until focus is
achieved. (P216)
• Images may look whitish when the lens or image sensor gets dirty with fingerprints or similar.
If the lens is dirty, turn the camera off, then wipe the lens surface with a soft, dry cloth.
For information about how to clean the image sensor, refer to P331.
• Ensure AE Lock is not set where it is not appropriate. (P110)
• When drive mode is set to [ ] (Burst), pressing and holding the shutter button will take burst
pictures. (P118)
• When bracketing is set, then pressing the shutter button records multiple images while
automatically changing the settings. (P144)
• Confirm the following details:
– Is the subject outside of the focus range?
– Is [Shutter AF] set to [OFF]? (P214)
– Is [Focus/Release Priority] set to [RELEASE]? (P216)
– Is AF Lock (P110) set where it is not appropriate?
• If there are fingerprints or dirt on the lens, the focus may be set to the lens and, as a result, the
subject may not be brought into focus.
• The shutter speed will become slower and the stabilizer function may not work properly when
recording in dark places.
In these cases, use a tripod and the self-timer when recording.
• Try the following:
– Reduce the ISO sensitivity. (P113)
– Increase [Noise Reduction] of [Photo Style] to the positive direction, or adjust each item other
than [Noise Reduction] to the negative direction. (P197)
– Set [Long Shtr NR] to [ON]. (P204)
Cannot record images.
The shutter will not operate immediately when the shutter button is pressed.
The recorded image is whitish.
The recorded image is too bright or dark.
Multiple images are recorded at once.
The subject is not focused properly.
The recorded image is blurred.
The stabilizer is not effective.
The recorded image looks rough.
Noise appears on the picture.
To Next Page
Loading...
Need help?
General
