323
12. Others
• When a moving subject is recorded while using the following functions, the subject may appear
distorted in the picture:
– [ESHTR]
– Motion picture recording
–[4K PHOTO]
This is a characteristic of the MOS sensor that is the image sensor of the camera, and is not a
malfunction.
• This is characteristic of MOS sensors which serve as the camera’s
pickup sensors.
This is not a malfunction.
• When using the electronic shutter (P206), lowering the shutter speed
may reduce the effect of the horizontal stripes.
• If flicker or horizontal stripes are noticeable when recording motion
picture, this can be mitigated by fixing the shutter speed.
Either set [Flkr Decrease] (P210), or record in Creative Video Mode (P180).
• Stripes may appear in high ISO sensitivity or depending on the lens you use.
Decrease the ISO sensitivity. (P113)
• When recording under fluorescent or LED lighting fixture, etc., increasing the shutter speed
may introduce slight changes to brightness or coloring.
These are a result of the characteristics of the light source and do not indicate a malfunction.
• When recording subjects in extremely bright locations or recording under fluorescent lighting,
LED lighting fixture, mercury lamp, sodium lighting, etc., the coloring or screen brightness may
change or horizontal striping may appear on the screen.
• Pixels may be missing from the image sensor.
Perform [Pixel Refresh]. (P237)
• When using a large capacity card, you may not be able to record for a while after turning on the
camera.
The subject appears distorted on the image.
Striping or flicker may appear under lighting such as fluorescent lighting and
LED lighting fixture.
Stripes appear in high ISO sensitivity.
The brightness or coloring of the recorded image is different from the actual
scene.
Bright spot not in subject is recorded.
Motion pictures
Cannot record motion pictures.
To Next Page
Loading...
Need help?
General
