12. Others
326
• Open the flash if it is closed. (P159)
• The flash does not fire when [Œ] (forced flash off) is selected. (P162, 163)
General tips for using a Wi-Fi connection
• Use within the communication range of the device to be connected.
• Usage near devices that utilize the 2.4 GHz frequency such as microwave ovens and cordless
telephones may result in the radio wave being lost.
Use the camera at a sufficient distance from these devices.
• When the remaining battery level is low, it may not be possible to connect to or maintain
communication with other devices.
(A message such as [Communication error] is displayed.)
• If you place the camera on a metal table or shelf, the radio waves may be adversely affected. In
such cases, you may not be able to establish a connection.
Move the camera away from the metal surface.
Wireless access point
• Confirm that the connected wireless access point can be used.
• Confirm the radio wave conditions of the wireless access point.
– Move the camera closer to the wireless access point.
– Change the location and angle of the wireless access point.
• Depending on the wireless access point, the radio wave may not be displayed even though it is
present.
– Turn off and then on the wireless access point.
– If the wireless channel of the wireless access point cannot be set automatically, manually set
the channel supported by the camera.
– If the wireless access point SSID is set not to broadcast, it may not be detected.
Enter the SSID, and then connect. (P287)
• From the Wi-Fi setting menu on the smartphone, turn off and then on the Wi-Fi function.
Flash
The flash does not fire.
Wi-Fi Function
A Wi-Fi connection cannot be established.
Radio waves get disconnected.
Wireless access point is not displayed.
The camera is not displayed in the Wi-Fi setting screen of the smartphone.
To Next Page
Loading...
Need help?
General
