Panasonic PT-REQ15 - Page 162

Chapter 4 Settings — [PROJECTOR SETUP] menu
162 - ENGLISH
Error message Measures to take
[Brightness Sensor Error]
f There is a problem with the brightness sensor. If problems persist even after switching on the
power, consult your dealer.
*1 “Multi Monitoring & Control Software” can be downloaded from the following website.
https://panasonic.net/cns/projector/
Note
f If the synchronized projectors are not displayed in the list, check the following:
g Are there devices with the same IP address on the network?
g Are the LAN cables connected correctly? (x page 213)
g Are the subnets of the projectors the same?
g Are the same [LINK] settings applied to a group?
f Refer to [PROJECTOR NAME] (x page 203) or [Network congs] (x page 245) on how to change the projector name.
Setting [STARTUP CALIBRATION]
Set whether to measure the brightness and color of the light source when the power is turned on.
1) Press as to select [BRIGHTNESS CONTROL].
2) Press the <ENTER> button.
f The [BRIGHTNESS CONTROL] screen is displayed.
3) Press as to select [STARTUP CALIBRATION].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF] Does not measure the brightness and color of the light source when the power is turned on.
[ON]
Measures the brightness and color of the light source by the brightness sensor after the power is
turned on and the light source is illuminated.
Note
f The [STARTUP CALIBRATION] setting will be reected at the time when the item is switched using qw.
f The [STARTUP CALIBRATION] setting item is common with the following menu item.
g The [PROJECTOR SETUP] menu → [BRIGHTNESS CONTROL] → [BRIGHTNESS CONTROL SETUP] → [STARTUP CALIBRATION]
Setting [REGULAR CALIBRATION]
Set whether to measure the brightness and color of the light source at a specied time.
1) Press as to select [BRIGHTNESS CONTROL].
2) Press the <ENTER> button.
f The [BRIGHTNESS CONTROL] screen is displayed.
3) Press as to select [REGULAR CALIBRATION].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF] Does not measure the brightness and color of the light source periodically.
[ON]
Measures the brightness and color of the light source by the brightness sensor at the time specied
by [CALIBRATION TIME].
f Proceed to Step 5) when [ON] is selected.
5) Press as to select [CALIBRATION TIME].
6) Press the <ENTER> button.
f The projector is in the adjustment mode (the time is blinking).
7) Press qw to select “hour” or “minute”, and press as or the number (<0> - <9>) buttons to set a
time.
f Selecting “hour” allows setting of only the hour in increments of one hour, and selecting “minute” allows
setting of only the minute in increments of one minute between 00 and 59.