Panasonic PT-REQ15 - Page 228

Chapter 5 Operations — Using the web control function
228 - ENGLISH
4) Enter a file name and click [Save].
f The le for signing request is saved in the specied folder.
Note
f The characters that can be input are as follows.
g Single-byte numbers: 0 to 9
g Single-byte alphabets: A to Z, a to z
g Single-byte symbols: - . _ , + / ( )
f The signing request generated by the projector is PEM format (le extension: pem).
f Apply issuing of the server certicate to the certication organization using the saved signing request le (PEM format).
Installing the certicate
Install the server certicate and the intermediate certicate issued by the certication organization into the
projector.
1) Click [Certificate] → [Server certificate] → [Install] → [Server certificate] → [Select files].
f A dialog to select the le is displayed.
2) Select the server certificate file and click [Open].
f If the intermediate certicate is issued from the certication organization together with the server certicate,
proceed to Step 3).
f If only the server certicate is issued from the certication organization, proceed to Step 5).
3) Click [Select files] in [Intermediate certificate].
f A dialog to select the le is displayed.
4) Select the intermediate certificate file and click [Open].
5) Click [Install].
f The server certicate and the intermediate certicate are installed into the projector.
Note
f To conrm the information of the installed server certicate, refer to “Conrming the information of the server certicate” (x page 228).
Conrming the information of the server certicate
Conrm the information of the server certicate installed in the projector.
1) Click [Certificate] → [Server certificate] → [Generated certificate information] → [Refer].
f The information of the installed server certicate is displayed. The details of each item are as follows.
Item Details
[Common name] The projector name or the IP address is displayed.
[Country] The country code dened in ISO 3166-1 alpha-2 (two upper case alphabets) is displayed.
[State] The State, etc. is displayed.
[Locality] The locality is displayed.
[Organization] The organization name is displayed.
[Organization unit] The organization unit name is not displayed. It is displayed as an asterisk.
[Validity start date] Displays the date and time that the self-signed certicate was issued.
[Validity end date] Displays the date and time that the self-signed certicate will expire.
[CRT- key]
[Last modied] The generation date and time of the CRT key is displayed.
[RSA key size] The key size of the CRT key is displayed.
Note
f The installed server certicate and the intermediate certicate can be deleted by clicking [Certicate] → [Server certicate] → [Generated
certicate information] → [Delete].
However, it cannot be deleted when [HTTPS] → [Connection protocol] is set to [HTTPS]. Delete it after changing the setting to perform the
HTTP communication.
To delete the server certicate within the valid period, conrm that the certicate le used for installing is available on hand. It will be
necessary when installing the server certicate again.