1. General Information
1-12
12
NIKOTA USA: PANTERRA SCOOTER SERVICE MANUAL
CHAPTER 1: INTRODUCTION
For general maintenance and repair of the
scooter, a complete basic set of metric sized
tools is required. This should include; Open-end
wrenches, sockets and ratchet, hex keys, straight
and Philips screw drivers, standard pliers,
needle-nosed pliers, wire cutters, wire strippers,
scraper, pin punch, hammer and soft faced mallet.
For a more extensive tear down and rebuild of the
scooter, there are a variety of special tools that
will be required. These include the following:
•Valve spring compressor
•Valve guide reamer
•Feeler gage set
•Slide hammer bearing and seal remover
•Bearing press
•Torque wrench
•Ring compressor
•Clutch spring compressor
•Fly wheel puller
•Electronic multi meter
Tool Requirements
To Next Page
Loading...