TRANSMISSION BELT
2
OIL DRAINAGE BOLT
AND WASHER
GEAR OIL INLET
HOLE/CHECK HOLE
Final check of gear engine oil reduction
Checking oil volume, build up main foot
rest so that build up body becomes
vertical on plain ground.
1. Dismount gear oil adjusting bolt after
stopping engine.
2. The oil level should be just under the
regulation screw bolt hole. Add gear oil when oil
level is too low.
•Gear oil recommended: SAE 90W
3. Build up gear oil regulator screw bolt.
4. Confirm whether or not the packing washer
is broken.
Changing Gear Oil
1. Remove gear oil adjusting bolt and drain oil.
2. Confirm whether or not packing washer is
broken.
3. Add recommended gear oil.
•Gear oil capacity: 0.12l-40ES
•Bolt torque: 0.9kg-m 780 lbs.
4. Check if there is any leakage after work is
performed.
Transmission Belt
1. Detach the left crankcase cover (9-2).
2. Check whether there is wear and tear of
transmission belt.
3. Change with new one when necessary or
during timely maintenance.
1
3. Scheduled Maintenance
3-8
40
NIKOTA USA: PANTERRA SCOOTER SERVICE MANUAL
CHAPTER 3: BODY COVER AND EXHAUST SYSTEM
To Next Page
Loading...