1. General Information
Technical Tips (continued)
1-6
6
NIKOTA USA: PANTERRA SCOOTER SERVICE MANUAL
CHAPTER 1: INTRODUCTION
•Make sure that all wiring connectors are fully
seated and lock tubs engaged.
•Check if almuce of connector is covered and
fixation is tight.
•Make sure that all protective covers are
properly in place over the wiring connectors.
•Never reuse damaged wire terminals or
connectors.
•Never reuse damaged wire terminals or
connectors.
•Replace all rubber covers on wire connectors
to prevent water from getting into the
connector.
•Strip of main wire must be fixed on assigned
position.
•Insulator of aluminum strip must be affixed to
wires.
•Make sure that all wiring harness retainers are
properly placed.
•Do not over tighten wiring ties to prevent
pinching of wires.
•Do not allow wiring harness to hang in loose
loops.
To Next Page
Loading...