15192 Triton Lane
Huntington Beach, CA 92649
Office Tel: 714-892-3400
Hotline Tel: 714-891-6533
www.ppedm.com
This document is the property of PPedm Corp. and contains proprietary and/or patented information and may not be reproduced in
part or in whole without the express written permission of the company. Perfect Point logo, Perfect Point
TM
and E-Drill
®
are
trademarks of PPedm, Corp. US and worldwide patents pending.
Water sprays excessively
out of hand-tool. Hand-tool
cannot be held easily
against work surface
Dielectric vacuum and water
connections incorrect.
Check water tube connections.
Tube connections at back of
utility cabinet should not be
crossed.
No cutting occurs. No water
evident. Burning smell
around electrode
Wrong Adapter in use for the
fastener being removed
resulting in the ground pin not
being depressed sufficiently –
typically a button-head tip is
being used for a flush head
fastener. Incorrectly adjusted
or damaged Ground Pin.
Select the correct tip Adapter
configuration for the fastener.
If the wrong tip is used then
the depression of the ground
pin will not be sufficient for
water flow, causing
overheating and damage to
the equipment.
To Next Page
Loading...
