10
100 Workshop Manual, TSD3450E, Issue 1
2800
To fit
1 Examine the sump seal and renew if necessary. Ensure that the machined surface of the sump is clean
before a new seal is fitted.
2 Clean the bottom face of the crankcase and also the bottom faces of the flywheel housing and the gear case.
3 Apply a bead of RTV silicone sealant, CV60888, at the four positions where the edge of the flywheel housing
and gear case joints will be in contact with the sump seal. The bead must cover completely the exposed edge
of the joints.
4 Fit the sump and tighten the bolts to a torque of 30 Nm (22 lbf ft); use the sequence shown (B).
5 Fit the sound suppression panel, if relevant.
6 Fill the engine to the correct level with oil of the correct grade and specification. Refer to the User’s
Handbook.
To Next Page
Loading...
