3
Workshop Manual, TSD3450E, Issue 1 41
2800
Valves
To remove and to fit Operation 3-7
Special requirements
To remove
1 Remove the cylinder head, Operation 3-5.
Note: If more than one valve is to be removed, make a note of the position of the valves as they are removed
from the cylinder head.
2 Put the cylinder head, flame face down, on a bench with a soft surface and release the valves by use of the
valve spring compressor, GE50026. Use the procedure given in Operation 3-6.
3 Withdraw the valves from the cylinder head.
4 Repeat the procedure for all valves which are to be removed.
To fit
1 Apply clean engine oil to the stems of the valves. Fit the valves to their original positions in the cylinder head.
2 Use the special tool, GE50026, and the procedure given in Operation 3-6, to install the valve springs.
3 Fit the cylinder head, Operation 3-5.
Special tools
Description Part number
Valve spring compressor GE50026
To Next Page
Loading...
