11
Workshop Manual, TSD3450E, Issue 1 107
2800
Drive for the fuel transfer pump
To remove and to fit Operation 11-4
To remove
1 Remove the fuel transfer pump (A2), Operation 11-2.
2 Remove four bolts and washers (A1) and withdraw the assembly of the pump drive and housing (A3) from
the gear case.
3 Remove the three bolts from the housing (B1) and remove the assembly of the bearings and gear (B2) from
the housing.
4 Remove the ‘O’ ring seal (B3) from the housing.
5 Inspect all components, renew any which are worn or damaged.
To fit
1 Fit the assembly of the bearings and gear (B2) into the pump drive housing (B1).
2 Retain the gear and bearings in the housing with the three bolts.
3 Fit a new ‘O’ ring seal (B3) to the housing.
4 Insert carefully the assembly of the pump drive and pump drive housing into the gear case. Retain with four
bolts and washers.
5 Fit the fuel transfer pump, Operation 11-2.
To Next Page
Loading...
