4–5
CAUTION
• If the engine switch indicator light
changes to orange colour, the system
may be malfunctioning. Without
switching “OFF” the engine, contact
an authorised Perodua Service Centre.
(If you switched “OFF” the engine, the
engine may have a problem to restart
again)
• If you notice the engine switch is
different from its normal condition
such as the following, do not operate
the switch.
• The engine switch stuck or get
caught
• Drinks or liquid spilled on the switch.
• The engine switch indicator light is
not turned “ON” even after you have
turned on the clearance lights.
Please contact an authorised Perodua
Service Centre immediately.
Precaution for engine switch
w WARNING
Emergency engine stop method
When you do the following operations,
engine will stop even while running.
However, do not operate the engine
switch except in an emergency while
running. It may lead to an unexpected
accident.
• Push and hold the engine switch
for more than 3 seconds or;
• Push the engine switch more than
3 times.
NOTE
• If stopping and starting of the engine
repeatedly at short intervals, there are
cases where the engine cannot be
started.
Wait for more than about 10 seconds
and perform the start-up operation of
the engine again.
• If you push the engine switch too fast,
you may not be able to switch modes
(engine start/stop). Make sure to push
the switch one by one.
• To prevent battery from running out,
during engine switched off, do not let
the engine switch turned to “ON” in a
long time.
• For automatic transmission vehicle, if
the shift lever is other than P range,
do not stop the engine.
If you stop the engine when the shift
lever is other than P range, engine
switch will change to “ACC” mode. This
could cause the battery flat.
• There are cases where the engine switch
is not working correctly even the smart
key is within the operating range. It may
depend on the location of the smart key
and surrounding conditions.
Sect 04_EN D42L.indd 5 24/10/2019 4:25 PM
To Next Page
Loading...
