7–12
Step 2: Automatic connection mode
1. The Audio System enters into Automatic Connection mode whenever the ACC power is turned ‘on’. The auto connection mode allows
automatic connection between last connected Bluetooth mobile phone with Audio System.
2. If the connected device is out of the range within 5 minutes (without proper Bluetooth disconnection), the unit will automatically re-connect
the last device. The “ ” indicator on display will be flashing during that period.
Remark : Auto connection mode is effective only for the mobile phone that last connected with the Bluetooth turned to ON.
Step 3: Auto-answering and manual answering selection
1. The Audio System allows the selection of “Auto-Answering” and “Manual Answering” by pressing the Bluetooth button 1 to switch to
selection item.
2. The sequence of selection is shown as below:
Auto-Answering
- System LCD display “AUTO ANS”
Manual Answering
- System LCD display “MANU ANS”
Press Bluetooth button for
more than 2 seconds until
a beep sound is heard.
Press Bluetooth button for
more than 2 seconds until
a beep sound is heard.
Step 4: When there is an incoming call or outgoing call
1. During Standby mode (Manual Answering), if there is an incoming call, the audio output will be cut-off automatically. The Audio System
will switch to Telephone mode and caller ID will be displayed.
The incoming call can only be accepted if the Bluetooth button 1 is pressed once. The incoming conversation can be heard from front
speakers.
2. At Standby mode (Auto-Answering), if there is an incoming call, the audio output will be cut-off automatically.
The incoming call can be accepted automatically after 5 seconds without pressing the Bluetooth button 1.
3. The volume level of the telephone conversation can be adjusted by pressing Volume button 3.
Sect 07_EN D42L.indd 12 25/10/2019 11:45 AM
To Next Page
Loading...
