14–6
Loosen
5. Loosen the oil filter with an oil filter wrench
and remove it by hand.
6. Apply a little new engine oil on the rubber
gasket of the new oil filter.
7. Tighten oil filter 3/4 turn after gasket
contacts mounting base.
Tightening torque: 10.0 2.0 N.m
(102 20 kgf.cm)
8. Reinstall the drain plug and new gasket.
Tighten the drain plug.
Tightening torque: 29.5 5.9 N.m
(301 60 kgf.cm)
CAUTION
Do not overtighten the oil filter and drain
plug. It could cause oil leakage.
9. Slowly pour engine oil.
For recommended engine oil and its
capacity, see Section 17.
10. Install the oil filler cap by hand.
11. Wait a few minutes and check the engine
oil level.
12. Run the engine and check if engine oil is
leaking from the oil filter or drain plug.
Any leak indicates improper installation
of the oil filter or drain plug.
13. Turn the engine off and wait a few minutes.
Check the engine oil level again and add
oil, if necessary.
1KR-VE Engine
1NR-VE Engine
Sect 14_EN D42L.indd 6 31/10/2019 5:38 PM
To Next Page
Loading...
