14–22
• If a newly replaced fuse quickly blows
out, have the vehicle checked by an
authorised Perodua Service Centre.
NOTE
If the cable is disconnected from the
negative terminal, any data concerning
EFI and electronically-controlled automatic
transmission system that have been
memorized through the diagnosis
functions will be lost.
The preset data of the clock and radio,
will be lost too.
w WARNING
To prevent a fire due to excessive
current flow;
• Never install anything in place of a
fuse even temporarily.
• Make sure to use only fuses with
the specified capacities.
Never especially use a fuse with
its amperage rating higher than
specified.
We recommend you keep a set of spare fuses
for emergency.
Fusible link check
If excessive amount of current should run
from the positive terminal of the battery to the
headlight circuit or the ignition switch circuit,
the fusible link will blow to prevent a fire.
Immediately call an authorised Perodua
Service Centre to repair the system.
w WARNING
Never install anything in place of a
fusible link even temporarily.
It may cause extensive damage to the
vehicle and a fire.
Fusible link
Check the brake fluid reserve tank if the
brake fluid level is between the “MAX” and
“MIN” lines.
If the brake fluid level is too low, slowly add
clean brake fluid to the “MAX” line.
For recommended brake fluid, see Section 17.
CAUTION
Wipe away spilt fluid thoroughly to prevent
paint damage.
Brake fluid level check
MIN
MAX
MAX
MIN
Sect 14_EN D42L.indd 22 31/10/2019 5:38 PM
To Next Page
Loading...
